CGS is recognized within the gas industry for providing a comprehensive range of low cost, high reliability gas detection for many applications. We have installed and commissioned natural gas, carbon monoxide & LPG sensors in applications such as boiler rooms, kitchens, car parks, aircraft hangers, factories and shopping centers.
The Natural Gas sensor should be mounted in accordance with certain considerations. Do not position next to burners, heaters or ovens where temperatures above the room ambient may be experienced. It is, if possible, better to mount the sensors on the opposite wall. This is, of course, dependent on the size of the protected area. Natural gas is lighter than air and will therefore rise, meaning the sensor should be mounted 10 Inches from the Ceiling of the protected area. The Natural gas detectors at detection will go into alarm at 10% of the low explosion level. This will trigger isolation of the power supply to the solenoid and as such isolation of the gas supply. This can then be rectified by resolving the leak, allowing the sensor head to clear and resetting the attached Merlin panel. For further information on our Merlin gas detectors please refer to our product data sheet.
CGS is recognized within the gas industry for providing a comprehensive range of low cost, high reliability gas detection for many applications. Below are the models available for the XS range of detectors:
- Natural Gas (Methane)
- Carbon Monoxide
For any other gas monitors not listed above, please refer to the TFT range of CGS gas detectors.
• Low level & high level alarm.
• Straightforward to install .
• Covered by Canadian Gas Safety 3 year warranty.
• Width – 5.2 inch
• Depth – 1.3 inch